Skyjack ZB12032, Руководство по эксплуатации

Страница: 14 / 73

TM
Page 14 December 2007
ZB12032
Section 1 - About Your Telehandler Safety Rules
• ENSURE ALL tires are
in good condition and
lug nuts are properly
tightened.
• ALwAYS maintain three
points of contact when
entering vehicle. Use
provided hand-holds and
steps only.
• DO NOT ascend or descend a grade when
elevated. When fully lowered, ascending or
descending, only grades up to rated maximum
listed in
Table 2.2 are permissible.
• DO NOT alter or disable safety devices.
• DO NOT try to start the telehandler by pushing
or towing. Such operation may cause severe
damage to the transmission - Refer to
Section 2 .
• DO NOT burn or drill holes in forks. Modifying
any part of telehandler or attachment affects its
capacity and/or stability.
• iF DRiViNG ON ROADS OpEN TO pUBLiC
TRAFFiC
respect the local regulations.
• THE OpERATOR’S CAB provides a falling
object protection structure (FOPS) and a rollover
protection structure (ROPS).
Do not make any
modification to this structure. If damaged, the
cab cannot be repaired. It must be replaced.
• STUNT driving and horseplay are prohibited.
• ALwAYS USE FRONT steering when traveling
on highways and public roads.
• ALwAYS USE FRONT steering when traveling
at high speeds.
• DO NOT change steering mode while the
telehandler is traveling. Change the steering
mode only when telehandler is stopped.
• ALwAYS look in the direction of travel. Reduce
speed and be especially careful when traveling
in reverse and/or turning. Bring the telehandler
to a complete stop before changing the direction
of travel.
• STAY CLEAR of pinch points and rotating
parts on the material handler. Getting caught
in a pinch point or a moving part can cause
serious injury or death. Before performing any
maintenance on telehandler, follow the shutdown
procedure on
Section 2.9-9 .
• DO NOT position the telehandler against
another object to steady the load.
Safety Precautions (Continued)
Know and understand all safety precautions before going on to the next section.