SJ3215, SJ3219, SJ3220, SJ3226, SJ4726, SJ4732, SJ4740
216380ACA
79
Move the MEWP through a doorway
Section 6 – Procedures
7.
Stay behind the MEWP.
8.
Make sure the
platform control console
points
in the same direction as the front of the MEWP.
9.
Turn the
main power disconnect
switch to the
on position.
10.
Pull the
emergency-stop
button on the base
control console.
11.
Turn the
off/platform/base key
switch to the
platform position.
12.
Pull the
emergency-stop
button on the platform
control console.
13.
Move the
inclined drive/level drive
switch
to the inclined drive (low speed/high torque)
position for reduced speed.
14.
Move the
lift/off/drive
switch to the drive
position.
15.
Use as low a speed as practical to drive the
MEWP forward through the doorway.
16.
Push the
emergency-stop
button when the
MEWP is safely through the doorway.
17.
Turn the
main power disconnect
switch to the
off position.
18.
Disconnect the
platform control console
from
the rear side of the base, and put it on the
platform.
19.
Unfold the guardrails if they were folded. Refer to
Section 6.9-3
or
Section 6.9-4
for the procedure
on how to unfold the guardrails.
WARNING
Before you operate this MEWP, make sure that
the guardrail system does not have loose or
missing lock-pins. The guardrail system must be
in the vertical position. Lock all pins correctly. An
incorrectly locked guardrail can cause a fall, which
can result in death or serious injury.
WARNING
Fall hazard. Make sure each lock-pin is correctly
installed with the detent ball of each lock-pin fully
through the hole. Failure to avoid this hazard could
result in death or serious injury.
20.
Put the
platform control console
back onto
the mounting bracket. Install the
lock-pin
in the
mounting bracket.
21.
Put the
control cable
into the railing clamp and
install the
lock-pin
.
WARNING
Fall hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
22.
Use the MEWP ladder to exit the platform.
23.
Connect the
platform control console cable
to
the
electrical connector
below the platform.
Содержание SJ 3215
