Skyjack SJ 3215, Руководство по эксплуатации

Страница: 75 / 114

SJ3215, SJ3219, SJ3220, SJ3226, SJ4726, SJ4732, SJ4740 216380ACA
75
Fold the guardrails Section 6 – Procedures
Figure 23 Guardrail lock-pin locations (SJ3215, SJ3219, SJ3220, SJ3226, SJ4726, SJ4732)
Extension handrail
lock-pin locations
Rear gate pin
location
Mid-rail pin
location
6.9-3 Unfold the guardrails (SJ3215,
SJ3219, SJ3220, SJ3226, SJ4726,
SJ4732)
1. Make sure the MEWP is on firm, level ground.
2. Make sure you fully lower the platform.
3. Push the emergency-stop button on the base
control console.
4. Turn the main power disconnect switch to the
off position.
WARNING
Fall hazard. Use a stable elevated surface that
gives you a solid footing to fold or unfold the
guardrails. You must be at eye-level height (at
a minimum) to the mid-rail. You must have your
hands free to fold or unfold the guardrails from
the external side of the MEWP. If you do not obey,
there is a risk of death or serious injury.
5. Remove the lock-pins from the extension
guardrail, the extension mid-rail, the rear
guardrail, and the rear mid-rail.
6. For MEWPs with full gate only:
Remove the tie-wrap from the rear-right railing
bar.
WARNING
Fall hazard. Install each lock-pin correctly with
the detent ball of each lock-pin fully through the
guardrail. The guardrail system must be in the
vertical position. An incorrectly locked guardrail
can cause a fall, which can cause death or serious
injury.
7. Unfold the extension guardrail, and install the
lock-pins on the extension mid-rail.
8. Unfold the right guardrail, and install the lock-
pins (at the front and center) on the right mid-
rail.
9. Unfold the left guardrail, and install the lock-pins
(at the front and center) on the left mid-rail.
10. Unfold the rear guardrail, and install the lock-
pins on the rear mid-rail.
NOTE
MEWPs with a half gate have 2 pins on the
rear gate. MEWPs with the full gate (optional
equipment) have 4 pins on the rear gate.