SKS Sweden Bonfiglioli Vectron ACTIVE CUBE ACU 201 Series, Руководство по эксплуатации, Страница: 119 / 260

09/08
Operating Instructions ACU
117
11.2 Stopping Behavior
The stopping behavior of the three-phase machine can be defined via parameter
Operation mode
630. Via the logic signals or digital inputs for the parameters
Start
clockwise
68 and
Start anticlockwise
69, stopping is activated. Assign digital inputs
or logic signals to these parameters. Dependent on the setting of
Configuration
30
the parameters are preset to digital inputs. By combining the digital input signals or
logic signals the stopping behavior can be selected from the following table.
Stopping Behavior
Operation mode
630
Start clockwise = 0 and Start anticlockwise = 0
Stopping behavior 0 Stopping behavior 1 Stopping behavior 2 Stopping behavior 3 Stopping behavior 4 Stopping behavior 5 Stopping behavior 6 Stopping behavior 7
S
ta
rt
c
lo
ck
w
is
e
=
1
a
n
d
S
ta
rt
a
n
ti
cl
o
ck
w
is
e =
1
Stopping behavior 0
(Free stopping)
0 1 2 3 4 5 6 7
Stopping behavior 1
(Stop
and Switch off)
10 11 12 13 14 15 16 17
Stopping behavior 2
(Stop
and Hold)
20 21 22 23 24 25 26 27
Stopping behavior 3
(Stop
and DC brakes)
30 31 32 33 34 35 36 37
Stopping behavior 4
(Emergency Stop
and Switch off)
40 41 42 43 44 45 46 47
Stopping behavior 5
(Emergency Stop
and Hold)
50 51 52 53 54 55 56 57
Stopping behavior 6
(Emergency Stop
and Brake)
60 61 62 63 64 65 66 67
Stopping behavior 7
(DC brakes)
70 71 72 73 74 75 76 77
Operation mode
630 of the stopping behavior is to be parameterized according to
the matrix. The selection of the operation modes can vary according to the control
method and the available control inputs.
Example: The machine is to stop according to stopping behavior 2 if the digital logic
signals
Start clockwise
68 = 0 and
Start anticlockwise
69 = 0.
Additionally, the machine is to stop according to stopping behavior 1 if the digital
logic signals
Start clockwise
68 = 1 and
Start anticlockwise
69 = 1.
To achieve this, the parameter
Operation mode
630 must be set to 12.
By selecting the stopping behavior you also select the control of a mechanical brake if
operation mode „41- Brake release“ is used for one digital output for controlling the
brake.
Operating Instructions ACU 117 09/08