Skov DA 1200 Wall Inlet, Руководство по монтажу

Страница: 9 / 32

2020.06.26
• 612321
DA 1200 Wall Inlet
14
413214 LPV door set for pull rod 8mm
If there are doors etc. in the wall where the inlets are
mounted, and you want to disconnect the pull rod
temporarily, there is a special set that contains the necessary
parts. The set makes it possible to maintain the correct
ventilation level manually and to reassemble the pull rod
easily.
1 unit per door.
15
413223 Door set for wire
The mounting set is used if the pull rod is led round a door.
1 unit per door.
16
433064 DA 1200 light trap complete
Used for DA 1200 brick-in inlet if light dimming is required.
The light trap light-tightness is 99.9 %, corresponding to
20,000 lux outside and 0.05 lux inside (0.05 lux corresponds
to 2.5 ppm).
1 unit per inlet.
17
433067 DA 1200 outside flange
The flange is included in article no. 433064, but it can also be
mounted on the outside of houses with DA 1211/1211B inlets
in order to
•
Increase the output to the same level as DA 1200.
Correct the number of inlets.
•
Make a nicer finish on the outside of the building.
The net can be mounted on the flange afterwards.
•
Give a broader flashing than 433281
433067 can be used when the distance between the inlets,
when placed side by side, exceeds 5 cm.
1 unit per inlet.
18
433066 DA 1200 light trap without flange
Used for retrofitting on DA 1200 when the flange is already
on the building and light dimming is required.
The light-tightness of the light trap is 99.9 %, corresponding
to 20,000 lux outside and 0.05 lux inside (0.05 lux
corresponds to 2.5 ppm).
1 unit per inlet.