Skov DA 1200 Wall Inlet, Руководство по монтажу

Страница: 7 / 32

2020.06.26
• 612321
DA 1200 Wall Inlet
4
433022 DA 1200 set w.screws x10 for block
Used for assembly of DA 1200 brick-in inlets where these are
to be mounted in blocks. Includes 40 units 5 × 45 mm
rustproof screws.
1 set per 10 inlets.
5
433112 DA 1200 air direction baffle, short
The air direction baffle is 7.5cm long. An air direction baffle
(short/long) is always used for adjusting the air jet in cold
weather, and to prevent Coanda-effect along the wall. The
baffle is used on all inlets. However, with two rows of inlets,
it is only necessary with a baffle on the upper row, provided
the inlets are placed right above each other.
1 unit per inlet or 1 unit per every second inlet.
6
433114 DA 1200 air direction baffle, long w. side pl.
The air direction baffle is 15 cm long and with side plates. An
air direction baffle (short/long) is always used for adjusting
the air jet in cold weather, and to prevent Coanda-effect along
the wall. The baffle is used on all inlets. However, with two
rows of inlets, it is only necessary with a baffle on the upper
row, provided the inlets are placed right above each other.
The long air direction baffle is used where the air jet range
and the Coanda-effect are especially important, e.g. in wide
houses.
1 unit per inlet or 1 unit per every second inlet.
7
433014 DA 1200 baffle plate
For reduction of external actions on the DA 1200 baffle plates
are used when one or more of the following conditions are
current:
•
The volume of the house is low (narrow and low with a
flat ceiling)
•
In detached buildings without shelter belts and the like
The baffle plate must be mounted on all inlets in the same
room and are not to be used together with Advanced Inlet
Control.
The baffle plate increases the requirements to the tightness of
the building and cannot replace external windshield.
The baffle plate does not reduce the inlet capacity.
1 unit per inlet.