General comments
13
“TA”
Here you can set if your navigation system should replay incoming traffic informa-
tion.
•
“
ON
” - all incoming traffic information is replayed. If TA is switched on, only TP
stations can be set.
•
“
OFF
” - Traffic information is not replayed.
Volume settings
“
VOL-ON
” - Setting the switch on volume of the system.
“
TA MIN
” - setting the minimum volume for traffic information.
“
NAV-MIN
” - setting the minimum volume for the voice response of the naviga-
tion.
“
TELEPHONE
” - if your vehicle is equipped with a hands-free system*, a call is
replayed via the navigation system. Here you can set the volume, with which you
can hear your conversation partner.
“
GALA
” - the volume of your navigation system is increased automatically with
increasing speed and thus high exterior noises. Here you can set the degree of
accentuation.
Note
If at a particular time of a traffic information or voice response the system volume
is higher than “
TA MIN
” or “
NAV-MIN
”, this is also performed in the system
volume.
Macro button settings
The macro button
can be assigned to one of the following functions:
•
“
ROUTE GUIDANCE
” - activates the route guidance, if a destination has already
been defined.
•
“
ROUTE OPTIONS
” - calls up the menu for selecting the route calculation.
•
“
ROUTE LIST
” - calls up the route list during an active route guidance.
•
“
LAST DESTINATIONS
” - shows the content of the memory - LAST
DESTINATIONS - of the navigation.
•
“
ALPH.DEST.MEMORY
” - calls up the alphabetically classified destination
memory.
•
“
GPS STATUS
” - shows the number of current GPS satellite receptions and the
geographic position.
•
“
TOGGLE TIME INFO
” - allows the switch-over between arrival time and
remaining travel time.
Fig. 7 Volume settings
Fig. 8 Macro button settings
A
29
s2ck.7.book Page 13 Friday, April 20, 2007 12:38 PM
