General comments
7
Calibration after tyre change
After a tyre change it may be necessary to calibrate the navigation
system again.
– Mark and confirm the menu point “
TYRE CHANGE
” in the menu
“
SETUP-NAVIGATION
” with the menu knob
.
After confirming the safety question the calibration is automatically started. An
information for the calibration procedure is shown in the display.
Note
During the calibration other functions of the navigation are not possible.
Care of the display
Carefully handle the display because dents and scratches can occur through pres-
sure of the finger or contact with sharp objects.
The display can be cleaned with a soft cloth and finger marks can be wiped away
with pure alcohol.
Note
Do not use solvent such as turpentine or petrol as they will corrode the display
surface.
Changing the navigation CD
Description
– Press the CD eject button
to change the CD. The navigation CD is
ejected.
– Carefully insert the new navigation CD with the inscription upwards as
far as possible into the CD case until it can be drawn in automatically
by the unit.
Caution
Only clean CDs without scratches and damages should be used, in order to guar-
antee a proper functioning of the navigation system.
•
Store the non-used navigation CD in the bag provided for this.
•
Never expose CDs to direct sun rays!
•
Please never write or affix the CDs!
Functional description of the buttons
Switching the system on and off
– The system is switched on or off by pressing the rotary/push knob
.
The audio source or the navigation status (if the last route guidance dates back
more than 30 minutes) which was active before switching the system off is acti-
vated.
If the key is pulled out of the ignition lock when the system is switched on, the
system switches off autmatically. You can switch on the system again by pressing
the rotary/push knob
. If the engine is switched off, the system (protection of the
vehicle battery before discharging) switches off automatically after approx. one
hour. This process can be repeated as often as desired.
If the system is switched off and the ignition key is withdrawn, a flashing LED indi-
cates that this is a system with an active anti-theft coding.
Note
•
Change the volume to the right or to the left by turning the rotary/push knob
.
A
25
A
4
A
19
A
19
A
19
s2ck.7.book Page 7 Friday, April 20, 2007 12:38 PM
