SKILTEC 9E DUETTE SKYLIFT POWERVIEW SYSTEM, Руководство по эксплуатации товара

Страница: 6 / 29

PRODUCT INFORMATION MANUAL
SECTION: 9E DUETTE
®
SKYLIFT POWERVIEW
®
SYSTEM
ISSUE DATE: NOVEMBER 2017 ORIGINATOR: SKILTEC
REPLACES ISSUE DATE: APPROVED BY: R.BOKTOR PAGE 6
■
Reveal Mount shades only: Light gap seals should be
inserted into the front channel of all four rails. Make
sure they are inserted in the correct orientation, as
shown.
■
Reveal Mount shades only:
If the angle of the installed shade will be
45° or steeper, slide two spacer blocks into the rear channel on the
underside of the bottom rail. The spacer blocks prevent the light gap seal
from over-compressing and ensure even positioning of the shade in the
casement.
■
Position the spacer blocks approximately a quarter the shade
width from each end of the bottom rail.
■
The plastic spacer blocks have tabs of 13mm, 10mm, and 6mm. If
necessary, break off the outer tabs to adjust the spacer block to the
appropriate size, so the shade fits evenly into the casement.
NOTE:
The spacer blocks are packaged with the corner covers.
Front of Shade
Light Gap
Seal
Back
of
Shade