SKILTEC 9E DUETTE SKYLIFT POWERVIEW SYSTEM, Руководство по эксплуатации товара

Страница: 14 / 29

PRODUCT INFORMATION MANUAL
SECTION: 9E DUETTE
®
SKYLIFT POWERVIEW
®
SYSTEM
ISSUE DATE: NOVEMBER 2017 ORIGINATOR: SKILTEC
REPLACES ISSUE DATE: APPROVED BY: R.BOKTOR PAGE 14
If You Have a Satellite Battery Pack...
Install the Batteries into the Battery Wand
■
Squeeze the cap latch to release and remove the cap.
■
Install AA Lithium batteries according to the instructions
on on
the battery wand label.
■
Replace the cap.
■
Align the tab with the end of the wand.
■
Press the cap on until it latches.
Mount the Satellite Battery Pack Behind the Bottom Rail
■
Remove the bottom rail cover.
■
Attach the wall mount bracket to the back side of
the bottom rail using the pre-drilled holes.
■
Remove the screws attached to the back side of the
bottom rail.
■
Attach the wall mount bracket using those screws.
NOTE:
With the satellite battery pack behind the shade, the minimum casement depth for
fully recessed mounting is 115mm. If there is not enough clearance for the satellite battery
pack to be mounted on the back side of the bottom rail, it may be mounted on the wall or
ceiling in any orientation. See “Mount the Satellite Battery Pack on the Wall or Ceiling” on
page 19.
■
Route the power cable from the shade
through the bottom left corner bracket and
plug into the socket in the battery wand or
the extension cable.
■
If using an extension cable, plug the
other end of the extension cable into
the socket in the battery wand.
■
Reinstall the bottom rail cover.
Proceed to ““Test the Shade” on page 16.
Tab Slot
Cap
Latch
Battery
Wand
Squeeze
Wall Mount Bracket
Back of
Bottom Rail