PRODUCT INFORMATION MANUAL
SECTION: 9E DUETTE
®
SKYLIFT POWERVIEW
®
SYSTEM
ISSUE DATE: NOVEMBER 2017
ORIGINATOR: SKILTEC
REPLACES ISSUE DATE:
APPROVED BY: R.BOKTOR
PAGE 24
5. Press
■
STOP to stop the shade’s movement anywhere along its travel.
6. While a shade is in motion, press the opposite of shade motion (
■
OPEN or
■
CLOSE) to
reverse direction.
7. Press
■
FAVORITE to send selected shade(s) to your preset “favorite” position. Refer to the
PowerView
®
Motorisation Remote Control Guide
on how to set a favorite position.
Further Operation and Programming Information
PowerView Pebble
®
Remote and/or PowerView Surface Remote Operation
For information regarding operation and programming of the PowerView remote, refer to your
PowerView Motorisation Remote Control Guide
.
PowerView Scene Controller
For information regarding operation and programming of the PowerView Scene Controller, refer
to your
PowerView Motorisation Scene Controller Guide
.
PowerView App Operation
PowerView Hub is required for PowerView App operation. For information regarding setup and
operation using the PowerView App, refer to the ALFI Blind Support Webpage
at
alfi.hunterdouglas.com.au
Resetting the Shade (If Necessary)
If you need to reset a shade’s travel limits:
Basic Reset
The basic reset is used to reset the shade’s travel limits.
1. Press and hold the manual control button for 6 seconds. The shade will move slightly.
2. Release the manual control button. The shade will raise to its fully open position to set the
upper travel limit, then lower to the fully closed position to set the lower travel limit. The shade
will move slightly one more time to indicate that the travel limits have been reset.
Resetting Shade Programming
This reset erases all shade programming from memory, including group assignments, preventing
any input device from operating the shade. Its primary use is during installation to correct group
and network assignments. This reset does not affect travel limits.
1. Press and hold the manual control button for 12 seconds. The shade will move slightly after 6
seconds, then again after 12 seconds. Release the button.
2. Refer to “Joining a Shade to a Group” on page 21 to program the shade to a group.
Содержание 9E DUETTE SKYLIFT POWERVIEW SYSTEM
Страница 2: ......
