SKF Spandau Pumpen PSR 02, Руководство по сборке и соответствующее руководство по эксплуатации, Страница: 8 / 32

1. Safety information Page 8
EN
In particular, note that this product is neither
designed nor approved for use with fluids
belonging to Group I (hazardous fluids) as defined
in Article 2, Paragraph 2 of Directive 67/548/EC of
27 June 1967.
The described product is neither designed nor
approved for use in conjunction with gases,
liquefied gases, gases dissolved under pressure,
vapours, or fluids with a vapour pressure of more
than 0.5 bar above normal atmospheric pressure
(1013 mbar) at the maximum permitted
temperature.
Unless explicitly stated otherwise, SKF Lubrication
Systems Germany GmbH products are not
approved for use in potentially explosive
atmospheres as per ATEX Directive 94/9/EC.
1.2 Authorized personnel
The products described in the assembly manual
may only be installed, operated, maintained, and
repaired by qualified experts. Qualified experts are
persons who have been trained, instructed, and
familiarized with the end product into which the
described product is installed.
These persons are considered capable of such
tasks due to their education, training, and
experience with valid standards, conditions,
accident prevention regulations, and assembly
measures. They are entitled to carry out the
required tasks and to recognize * and thus avoid *
any dangers that might otherwise occur.
A definition of what constitutes a qualified person
and information on the prohibition on allowing
work to be carried out by unqualified personnel are
stipulated in DIN VDE 0105 and IEC 364.
1.3 Danger relating to electric current
The electrical connection for the described product
may only be established by qualified, instructed
persons who have been authorized to carry out the
task at hand by the operator. All local electrical
operating conditions and regulations such as DIN
and VDE must be observed. Improperly connected
products can result in considerable damage to
property and injury to persons.
Working on products which have not
been disconnected from the power
supply can cause injury to persons.
Assembly, maintenance, and repair
work may only be carried out by
qualified experts on products that have
been disconnected from the power
supply. The supply voltage must be
turned off before any product
components are opened.
1.4 Danger relating to hydraulic
pressure
The described product is under pressure
when it is being operated. It must
therefore be depressurized before
assembly, maintenance, or repair work
begins and before any changes to the
system are made.