SKF Spandau Pumpen PSR 02, Руководство по сборке и соответствующее руководство по эксплуатации, Страница: 17 / 32

6. Transport, delivery, and storage Page 17
EN
6. Transport, delivery, and
storage
Products from SKF Lubrication Systems Germany
GmbH are packaged as is usual in the trade in
accordance with the conditions of the recipient
country and in accordance with DIN ISO 9001. Our
products must be transported with care. Products
must be protected against mechanical influences
such as impacts. Transport packaging must be
labelled with the information 'Do not drop!'.
The product must not be tipped up or
dropped.
There are no restrictions relating to land, air, or sea
transportation.
Following receipt of the shipment, the product or
products must be checked for damage and the
shipping documents should be used to make sure
that the delivery is complete. Keep the packaging
material until you are sure that there are no delivery
discrepancies that need to be clarified.
The following conditions apply to the storage of
products from SKF Lubrication Systems Germany
GmbH:
6.1 Pump units
•
The pump must only be transported in the
proper manner using the transport lugs.
•
It must be stored in a dry, dust*free, low*
vibration (v
eff
≤
0.2 mm/s) environment.
•
In the case of a relatively long period of storage,
the bearing grease service life decreases.
•
In the case of storage lasting more than 12
months, the state of the grease must be checked
prior to recommissioning. In addition, the
insulation resistance of the motor winding to the
housing must be measured. In the case of values
of
≤
1 k
Ω
per volt of rated voltage, the motor
winding must be dried out.
6.2 Electronic and electrical devices
•
Ambient conditions: Dry, dust*free environment;
storage in well*ventilated, dry area
•
Storage time: 24 months max.
•
Permitted air humidity: < 65%
•
Warehouse temperature: 10 * 40°C
•
Light: Direct sunlight/UV radiation must be
avoided; nearby sources of heat must be
screened.
6.3 General information
•
Ensure that no dust gets into stored products by
wrapping them in plastic film.
•
Store products on racks or pallets to protect
them from rising damp.
•
Before placing products into storage, protect
uncoated metal surfaces * and drive parts and
mount surfaces in particular * from corrosion
using long*term corrosion protection.
•
At 6*monthly intervals: Check products for
corrosion. If signs of corrosion are found,
improve the corrosion protection measures.
•
Drives must be protected against mechanical
damage.