SKF LAGD 1000 series, Инструкция по эксплуатации

Страница: 17 / 37

17 SKF LAGD 1000
When the unit is illed for the irst time, the lubricant forces the follower (rubber ring plate)
upward until the overill outlet hole is reached. As illing continues, the air escapes until
the entire reservoir is illed with lubricant. When excess lubricant starts to emerge from
the overill outlet, stop illing completely. When topping up, take care not to let lubricant
emerge from the overill outlet hole. The levels (minimum and maximum) of the grease in
the container are shown by the rubber ring below the metal plate. Figure 13 clearly shows
the minimum, maximum and overill details.
Fig 13 Position of grease illing marks
2.5.4 Bleeding the system
Connect the grease gun to the nipple shown as B in igure 12, and pump until the
lubricant emerging from the distribution block is free of air. The pressure relief valve is
used to protect the entire lubrication system against excessive internal pressures. The
valve is set to open at a pressure of 150 bars. If the operating pressure increases beyond
150 bars due to a blocked progressive feeder or lubricating point, the valve opens, and
grease visibly emerges from the valve.
2.5.5 Installation of lubrication pipes
Carefully cut the lubrication pipe to the correct lengths for the application.
1. Minimum level of grease
2. Grease
3. Maximum level of grease
4. Follower plate
5. Overill outlet hole