Depending on the option, the CPMT is delivered with either a DIN-8
connector or a flying leads cable.
Connecting DIN-8 plug to control unit
The insertion position is dictated by the geometric shape of the plug.
Strain relief for this system is provided via attached components of
the respective SKF control unit casing.
1
Check the sealing ring of the DIN-8 plug (arrow) and the plug, for
any damage (
†
fig. 2
).
2
Lightly apply lubricant, Klübersynth VR 69-252 (part no.
0118037), to sealing ring (arrow).
!
Note!
A low-voltage plug connects the device to an external
control unit. Follow the SKF control unit’s operating manual
instructions during the connection process.
!
Note!
Damaged sealing rings and twisted plugs can no longer
guarantee protection pursuant to IP40. They must be replaced
by the manufacturer (
† chapter 5.2
Transport inspection,
page 26
).
Damage due to wrong lubricants
The use of incorrect additives may cause significant material
damage.
Therefore:
•
Use only the auxiliary products listed by the manufacturer
.
C A U T I O N
Fig. 8
35
www.lmotion.ru
Тел
.: (495)-921-34-60