Structure and function
Outer tube base plate (a1)
The outer tube base plate has four holes to access attachment bores
in the outer tube
(b1
) for the mounting screws. This enables the pil-
lar to be fastened to one side of the application. The outer tube base
plate must be attached permanently with fastenings screws M10 to
a metal plate in the application, which has to support the areas of
force distribution (
c1
,
c2
).
Motor cable (a2)
The cable (
a2
) exits to one side at the outer tube base plate (
a1
) and
has to be connected to an external control unit via the DIN-8 plug or
the flying leads cable attached.
Outer tube (a3)
The outer tube is the tube with the largest outside dimensions. The
CPMT pillar can be mounted in any orientation to place the outer
tube (
a3
) at the top or bottom of the application.
Middle tube (a4)
The middle tube is the tube between the outer and inner tubes.
Inner tube (a5)
The inner tube is the tube with the smallest outside dimensions. The
CPMT pillar can be mounted in any orientation to place the inner
tube (
a5
) at the top or bottom of the application.
Rim covers (a6)
The purpose of the rim covers for the outer and middle tube is to
protect the tube guiding system from dust and to prevent the
ingress of foreign matter. The rim covers must not be removed
under any circumstances.
Glide pads (a7)
The purpose of the glide pads (
a7
) is to provide a stiff, virtually play-
free guiding of the tube sets.
Inner tube base plate (a8)
The inner tube base plate has four holes to access attachment bores
in the inner tube (
b1
) for the mounting screws. Its purpose is to fas-
ten the pillar to one side of the application. The inner tube base plate
must be attached permanently with fastenings screws M10 to a
metal plate in the application, which has to support the areas of
force distribution (
c1
,
c2
).
Mechanical safety end-stops (a9)
The purpose of the mechanical safety end-stops (
a9
) is to block the
extension of the tubes in the event of failure of the end limit
switches. This is a safety mechanism only.
Areas of force distribution (c1, c2)
The outer and inner tube base plates must be attached to a support
plate in the application. The areas of force distribution have to be
supported in the application by an adequately dimensioned support
20
www.lmotion.ru
Тел
.: (495)-921-34-60
