25
2
21/01/16 Rev:3.0.0
English
9.7.1 Connection to the piping network (cyclonic suction see pages 10-12)
1. Using the sleeve, connect the dust inlet coupling of the cyclonic vacuum cleaner, identi
fi
ed with (A)
in the picture, to the suction pipe from the piping network.
2. Using the sleeve, connect the venting air coupling of the central vacuum cleaner, identi
fi
ed with (B),
to the air exhaust pipe of the house.
3. Glue the silencer (C) on the exhaust pipe near the exhaust air grid.
4. Install the service suction inlet (D) in the lower hole being careful to insert the gasket between the
appliance and the suction inlet.
5. Use the screws and the washers provided with the BI-VAC kit to screw the service inlet to the applian-
ce’s body from inside the cylinder.
N.B.: do not glue the pipe end of the network pipe to the dust inlet coupling or to the air exhaust coupling:
always use the sleeves provided.
C
A
D
B
