45
2
21/01/16 Rev:3.0.0
English
Reassemble the dust container in its housing under the vacuum cleaner and close it again.
Switch the vacuum cleaner on by pressing the ON/OFF switch. After restarting the central vacuum unit,
press RESET to cancel the alarm relating to the dust container (bag).
12.6 Dust collection, transfer and disposal
Where a separated refuse collection policy is in place, once removed from the vacuum cleaner, the dust
collected in dust bins and dust bags must be placed in the green “dry, non-recyclable waste” bins.
12.7 Disposal of the fi lter cartridge
Introduce a new dust bag
3
ATTENTION
YOU SHALL ALWAYS CHECK THE RIGHT POSITIONING AND
TIGHTENING OF THE FILTER CARTRIDGE. A WRONG POSITIO-
NING OR A LOOSE FILTER CARTRIDGE MAY CAUSE A SERIOUS
DAMAGE OF THE PRODUCT.
DO NOT USE THE VACUUM CLEANER WITHOUT THE FILTER
CARTRIDGE. ENSURE YOU HAVE REPLACED A SPARE FILTER
CARTRIDGE BEFORE CARRYING OUT THIS OPERATION.
The
fi
lter cartridge can be restored as follows:
1A) blowing its surface with compressed air
1B) vacuuming its dirty surface with the vacuum unit, with a clean
fi
lter previously installed. In this case,
we recommend to shake the dirty
fi
lter, before vacuuming, to eliminate most of the dusts that deposit
between the folds.
NB Check the
fi
lter surface is not cut. If this is
the case, the
fi
lter cartridge should not be used
again and should be de
fi
nitely replaced.
1C) washing it under
fl
owing water. Also in this case we recommend to shake
the
fi
lter before washing it in order to eliminate most of the dusts that deposit
between its folds.
ATTENTION: before replacing the fi lter cartridge back in the system after
washing, ensure it has completely dried. DO NOT reassemble the fi lter if
the surface is still wet or damp.
