PUTTING THE MEASUREMENT SYSTEM INTO OPERATION
SICAT JMT
⁺
Jaw Motion Analysis System
Page 21 of 37
CAUTION
SICAT is unable to accept any liability for damage or functional errors that are
caused by faulty software installation or unsuitable computer hardware. If the
operator installs additional hardware or third party software, this occurs based
on the sole responsibility of the operator and is not covered by the
manufacturer's liability. The computer needs to be CE-marked and needs to
satisfy the requirements of DIN EN 60950 and/or DIN EN 60601-1.
CAUTION
The SICAT JMT
+
system is not intended for operation in a network/data pool.
Connecting the system to a network/data pool can cause unforeseen risks to the
patient and third parties. If the database of the SICAT JMT
+
software is installed
in a network/data pool, the operator is obliged to ascertain, analyze, evaluate
and manage all of the associated risks. In this context, the aspects of data
protection, virus safety, updates to the operating system and regular backups
are of particular importance. The risk assessments also have to include the
subsequent changes to the network/data pool, such as updates/upgrades to
devices and components that are connected with the network.
INSTALLING THE SICAT JMT
⁺
SOFTWARE
Installation instructions are provided in the operating instructions on the SICAT JMT
+
software.
NOTICE
Please make sure under all circumstances, that before connecting the
measurement system and PC with the USB cable and/or via Bluetooth, that you
have installed the SICAT JMT
+
software.
If this step is omitted, problems can occur during the installation of the device driver, as the Windows
operating system registers the location of the driver on the hard disk on the occasion of the first
connection of the SICAT JMT
+
system and the PC.
If no corresponding SICAT JMT
+
software is installed on the PC yet, the mapping of the driver will fail for
the above reasons, and the SICAT JMT
+
system may not function correctly.
NOTICE
If problems should occur with the hardware driver of the SICAT JMT
+
system,
please unplug the USB cable from the PC and start it again. Now, re-install the
SICAT JMT
+
software and create the connection once again.
CONNECTING THE ACCESSORY PARTS
Connect the head bow, LJ-sensor and possible foot switch with the corresponding colored sockets on the
measurement system. (Images see
Control elements and connections [
▶
Page 12]
)
NOTICE
When connecting the headband, LJ-sensor and foot switch to the measurement
system, please ensure that the plugs are protected against false polarity / being
plugged into the wrong socket with a keying nose. All of the plugs should go into
the sockets easily and without much effort.
Next, connect the measurement system and a USB interface on your computer with the USB cable
provided, or set up the Bluetooth connection. In this context, it is necessary to ensure that the
measurement system is switched on. Your measurement system is now ready to use. Detailed
instructions on the operation of the SICAT JMT
+
system are provided in the operating instructions for the
SICAT JMT
+
software.
4.3
4.4