20 | Sinterit INTERTEK Vacuum Cleaner USER MANUAL
9. Cleaning the Filtering chamber
ATTENTION!
Any maintenance or cleaning job must only be executed in NOT-
CLASSIFIED atmosphere, which means an area with a non potentially
explosive atmosphere.
ATTENTION!
Before starting any maintenance or cleaning job, always wear adequate protective
clothing, eyewear, face mask, and/or gloves according to the type of job to be done.
1. Set on the castors brake to ensure that the machine is stable.
2. Turn off the vacuum cleaner by switching the Power Switch from “1” to “0”.
3. Disconnect the vacuum cleaner plug from the power supply.
4. Release the Antistatic hose from the Suction hose connector.
5. Release the two Release fasteners
5
that hold the Motor Head (Image 13).
6. Lift the Motor Head and rest this on a flat surface being careful not to damage the Power cable.
7. Disconnect the internal grounding
16
from the connector
21
to get to the Main Star filter (Image 14).
5
21
16
Image 13. Release the Release fasteners.
Image 14. Disconnect the internal grounding
16
with connector
21
.
8. Remove the Main Star filter. Watch out for the powder on the filter surface, especially underneath! Put the Main Star
filter on a tray (you will avoid spilling powder around the area).
9. Empty the Filtering chamber from the powder or dust into special containers.
STOP!
Empty the contents of the Filtering chamber into a special waste disposal
container in accordance with laws applicable in the country where the vacuum
cleaner is used.
10. Put the Main Star filter back in place.
11. Connect the internal grounding!
12. Fit the Motor Head back on and secure with Release fasteners.
CAUTION!
Danger of crushing upper limbs when fitting and locking the Motor Head on the Filtering Chamber.
13. Fit the necessary accessories, connect the power supply and grounding. Start working again.
