Chapter 1. Important Safety Instruction
1-2
Attention: An appropriate interface cable
and power cable will be required to use
this printer.
Warning: Secure the power
cable firmly.
Warning: The thermal head
reaches high temperature during
operation but this is normal. Do
not touch the thermal head.
Warning: Do not attempt to
service for the printer beyond the
instruction specified in this
document. In case it is
impossible to recover the problem,
please contact to the dealers or
service center.
Warning: Only specified power
cable should be used, and please
make sure that it is connected
properly before turn the printer
power on. If do not operate
correctly, it may cause fire or
electric shock.
Also, there is a possibility to occur
radio or television
signal-receiving interference.
In the case you cannot connect
properly, please contact to the
dealers or services center.
Warning: Never disassemble or
modify the printer.
Some sections of the printer
contain a high voltage or become
very hot. Ignoring this warning
may cause electric shock, fire or
burns.
Warning: The card will be
released from the discharge port at
a high speed. Do not look into the
outlet while in use. It may cause
blindness or injury.
Warning: If the fan motor failure,
it may cause fire. For replace it
please contact to the dealers or
service center.
Handling Instruction
In handling the printer, please pay attention to
the followings;
Warning: Lift the printer from
its box and put it onto a flat table
or desk.
Warning: Be careful when you
transport the printer on the
slippery floor.
Warning: In case you drop the
printer, firstly turn off the power
of the printer and remove the
power cable, then contact the
dealers or service center. If use
the printer without any checking,
may cause fire or electric shock.
Warning: The printer is too
heavy to be lifted by one person.
(Nearly 23 Kg)
Please take a good care of your
hands and fingers when lifting
the printer from the box.
Attention: Touching the surface of the
thermal head directly may cause damage
to thermal head. When hard object get
into the printer, it may cause damage to
the printer mechanism. In such case,
please stop to use the printer.
