Sindoh A1 Series, Руководство пользователя

Страница: 19 / 133

- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
③ CAUTION
Any changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
④ This product has the certification issued under the authority of the FCC by one of Certification
Body.
FCC ID : 2AB83-A1
⑤ IC Compliance
This Class [A] digital apparatus complies with Canadian ICES-003.
Cet appareil num rique de la classe [A] est conforme la norme NMB-003 du Canada.
❖ Wireless LAN Specifications
The wireless device may be affected by electromagnetic interference so it should not be used for
like saving services.
❖ WLAN Notice
Exposure to radio frequency radiation:
The following notice is applicable if your printer has a wireless network card installed.
The radiated output power of this device is far below the FCC radio frequency exposure limits.
A minimum clearance of 20 cm (8 inches) must be maintained between the antenna and any
persons for this device to satisfy the RF exposure requirements of the FCC.
❖ Power Consumption
Power Consumption of the Products:
The table below shows power consumption.
Mode Description Power Consumption
Printing A device is printing using electronic input data. 250W
Standby A device is in standby mode. 50W (Heater OFF)
160W (Heater ON)
Power Off A power plug is plugged into the outlet with the machine’s
switch off. Less than 0.5W
The above power consumption is the hourly average value.
Instant power consumption can be much higher than the average value.
Deactivated Mode
The machine consumes power even in the deactivated mode. Unplug the power cord to
completely stop the power consumption.
Before Using the Device