Simuline Cycraft, Инструкция по установке и эксплуатации

Страница: 47 / 74

Page 47
6.2 TURNING THE POWER ON AND OFF
Before you power-up Cycraft, make sure of the following:
1) The power cord is connected to the correct voltage outlet and the green main
power LED is lighted.
2) The power cutoff switch and motion stop switch (behind the coin chute tower) are
released.
Make sure there are no personnel or objects near or under the cabin before
switching the power on in order to prevent damage and injury.
Make sure there are not passengers in the cabin when power is turned on.
The extra weight of the passenger can cause a fault in the power ON
sequence.
To power ON Cycraft , switch the cabin power switch ON and press the green
“SYSTEM ON” button on the operator panel for about 3 seconds. The power up
sequence will proceed automatically according to the following sequence:
1) The main power contacts will close with a few clicking sounds and the MCU power
LED, cabin power LED, and the LCD panel will light up.
2) The monitor screen inside the cabin will show the start-up sequence of NAOMI2 or
Triforce game board.
3) The cabin will pitch UP fully and slowly put itself to the horizontal initial position.
Also, the steering wheel will rotate slowly to the right and left limits and then come
to rest in the neutral position. Make sure the steering wheel is not obstructed
during this process.
4) When the “SYSTEM ON” sequence is complete, the cabin monitor will show the
game’s graphics screen with the message “Insert Coin to Start”.
Upon successful SYSTEM ON, the Operator Panel LED’s and the LCD display will
indicate as follows: