Simrad SU90, Приемо-сдаточные испытания в порту

Страница: 47 / 62

409977/B
47
a If you use the motion sensor in the Motor Control Unit on the hull unit, make
sure that
LAN
is selected.
The sensor uses a local area network (LAN) port on your Processor Unit. A
message on the page verifies that it is connected to the SU90 beamformer
application.
b If you use an external motion reference unit (MRU), make sure that a COM
port is selected, and that the correct parameters are provided.
4 On the left side of the
Installation
dialog box, select
Installation Parameters
to open
the page.
a Open the
MRU
(Motion Reference Unit) page.
b Make sure that the installation parameters for the motion sensor (offset and
rotation) are correct.
The physical location of the sensor (X, Y and Z offsets) must be extracted from
the detailed vessel drawings, or from the reports provided by the personnel that
did the actual installation. The information about the installation angles must
be extracted from the reports provided by the personnel that did or measured
up the actual installation.
5 Close the
Installation
dialog box without making any changes.
6 Observe the top bar.
7 Make sure that the information from the sensor is displayed.
If necessary, enable the read-out in the
Display Options
dialog box.
Note
In order to read the motion compensation values, the SU90 must be "pinging". As
long as the vessel is in port, you can not expect major changes in the values.
8 If possible, use another instrument to verify that the information provided by the
SU90 is correct.
9 Fill in the result tables.
Result
Port Baud rate Protocol
X Offset Y Offset Z Offset
Testing the interfaces with peripheral devices