Simrad SN90, Руководство оператора

Страница: 43 / 188

381295/B
41
5 Select
Bearing
.
6 Make the necessary adjustment.
The following methods can be used to adjust this setting:
a Select [ + ] or [ - ] to choose the requested setting.
b Place the cursor on the button. Press and hold the left mouse button. Move the
cursor horizontally over the button. Release the mouse button when requested
value is shown.
c Select the middle of the button to open it. If you have a keyboard connected to
the SN90, type the requested value.
7 Open the button and select
Apply to all
if you wish to use the chosen setting in all
the views in the current presentation mode.
Related topics
Starting normal operation, page 26
Turning off the SN90
Select
Power Off
on the top bar to turn off the SN90. You can also use the
Power
button
on the Operating Panel. You must never turn off the SN90 by means of the on/off switch
on the Processor Unit.
When you do not use the SN90, turn off the display and the Processor Unit.
A hull unit may be provided as an optional method to lower and hoist the transducer.
This task assumes that a hull unit is installed. If a hull unit is not installed you can
disregard information related to lowering and hoisting the transducer.
Procedure
1 Select
Power Off
on the top bar.
In the
Power Off
dialog box, select
Power off
or
Exit to Operating System
.
•
Power Off
turns off the Processor Unit and the Transceiver Unit.
•
Exit to Operation System
closes the SN90 program, and turns off the
Transceiver Unit.
• Both functions will also retract the transducer.
or:
2 On the Operating Panel, press
Power
, and keep it depressed for a few seconds.
Getting started