17
SimpliFire • SF-BI30-E, SF-BI36-E • 2040-900 Rev. C • 2/13
15. Align C-channel with screw holes in appliance.
16. While supporting glass, install both screws through
top C-channel retainer into appliance.
17. Install front by aligning the tabs on its back side with
the spring clips on the face of the appliance. Press
evenly with two hands to fully engage the front to the
appliance.
12. Install rubber plugs into holes in each end of grate.
See Figure 6.3.
13. Install glass into bottom retainer channel.
14. Install C-channel on top edge of glass panel. See
Figure 6.2.
F. Replacement Instructions
WARNING! Risk of Shock! Always disconnect power
before disassembly or servicing.
Front Replacement
1. If necessary, place a drop cloth or other material on
the hearth or flooring to prevent scratching. Grasp
front with two hands. Pull straight back to disengage
front from appliance.
2. Install replacement front by aligning the tabs on its
back side with the spring clips on the face of the ap-
pliance. Press evenly with two hands to fully engage
the front to the appliance.
Glass Replacement
1. If necessary, place a drop cloth or other material
on the hearth or flooring to prevent scratching. Grasp
front with two hands. Pull straight back to disengage
front from appliance.
2. Locate C-channel that retains top edge of glass
panel. While supporting the glass, remove the screw
located in the C-channel at the top two corners of the
glass panel. See Figure 6.2.
3. Pivot glass away from appliance and lift out of bottom
retainer channel.
4. Install replacement glass into bottom retainer chan-
nel.
5. Install C-channel on top edge of replacement glass.
6. Align C-channel with screw holes in appliance. See
Figure 6.2
7. While supporting glass, install both screws through
top C-channel retainer into appliance
8. Install front by aligning the tabs on its back side with
the spring clips on the face of the appliance. Press
evenly with two hands to fully engage the front to the
appliance.
3. Pivot glass away from appliance and lift out of bottom
retainer channel.
4. Locate rubber plugs in each end of the grate.
Remove plugs with a small flat screwdriver. Save for
later use. See Figure 6.3.
5. Remove Phillips screw from each end of grate. Lift
grate from faux ember bed. Take care to retain
screws with grate. See Figure 6.3.
6. Grasp log ember bed and lift up and out of opening.
Rotate ember bed to expose electrical wiring.
7. Disconnect lighting LED power source pin connector
from back side of ember bed. See Figure 6.4.
8. Connect lighting LED power source pin connector to
back side of replacement ember bed. See Figure 6.4.
9. Rotate log ember bed and align with floor of opening.
Engage back side of ember bed into the opening.
Pivot the front of the ember bed into position flat on
the floor of the opening. Take care not to pinch wiring
under log ember bed.
10. Align the grate, with the retained screws, with the
steel brackets under the ember bed. Ensure that
wiring is not pinched between log ember bed and
steel bracket.
11. Install and tighten the screw in each end of the grate.
See Figure 6.3.
Log/Grate Replacement
1. If necessary, place a drop cloth or other material on
the hearth or flooring to prevent scratching. Grasp
front with two hands. Pull straight back to disengage
front from appliance.
2. Locate C-channel that retains top edge of glass
panel. While supporting the glass, remove the screw
located in the C-channel at the top two corners of the
glass panel. See Figure 6.2.
