Setting the Meter
-
7
Installing Control Power:
Please see wiring diagram in the drawing packet
shipped with the unit.
Float Assembly
Installing Float Assembly:
To install the float assembly, push the
latch handles on the assembly down and
slide the coupler off.
Apply an appropriate thread-lock to the
threads on the coupler and screw it into
the appropriate tank port.
Slide the assembly into the coupler and
lift the latching arms until the assembly is
locked into place.
Please see wiring diagram in the drawing
packet shipped with the unit.
:
Entering the Setup Menu:
There are a number of option for configuring
the meter, but only two concern us:
dSP 2,
which allows you to see approximately how
many gallons remain in your tank, rather than
a percentage; and
OFSEt
, which calibrates the meter for greater accuracy.
To enter the meter's setup menu, press and hold the
SEL
button for one
second. The screen will begin alternating between
Pro
and
NO
. Press
RST
while it shows Pro and you will be in the setup menu.
From here, pressing
RST
will cycle through five options, but all the setting
you will need to change are in the first,
1-INP
. Press
SEL
to enter the
category, and the meter will display
rANGE
.
Changing the Display From Percentage to Gallons:
When the meter display
rANGE
, press
SEL
nine times. The meter should
now read
dSP 2
. Press
RST
to change the value, which should initially be
100. Press
RST
to increase the flashing digit and
RST
to move one digit
left. Change the value to the maximum capacity of your tank, measure in
gallons. Press and hold
SEL
to return to the menu, then press
SEL
three more times until
NO
is displayed. The meter should exit the menu
on its own after about a second.
Meter
III-B. SETTING UP THE METER
