Simplex 4100U-S1, Руководство оператора

Страница: 13 / 86

1-3
The Simplex 4100U-S1 Fire Alarm Control Panel (FIP) has three general functions.
•
It monitors fire alarm initiating points (smoke detectors, heat detectors etc.).
•
It activates fire alarm notification devices (bells, strobes, brigade call) when an initiating
point activates.
•
It monitors and controls ancillary building equipment (fan controls, relays, etc).
Note: The term point is used extensively throughout this manual. It is a generic
term used to refer to an individual component of the system, such as a single
smoke detector, a single break-glass manual call point, etc.)
The operator interface, shown in Figure 1-2, allows a system operator to control and monitor
the site-specific components connected to the 4100U-S1 FIP.
Figure 1-2. Operator Interface
Table 1-1. Components of the Operator Interface
LED/ Description Refer To
Zone Alarm LED This LED flashes when any Zone
Alarm LED is on and the zone is not
isolated. It goes steady when all
zones in alarm are isolated.
Control Keys
Typical functions include: Alarm Test,
Fault Test, Bell Isolate, Warning
System Isolate & ACF Isolate.
Chapter 1
ALARMS
Fire Alarm LED
The Fire Alarm LED flashes to
indicate the presence of an
unacknowledged alarm condition.
Other components of the system,
such as the horns and strobes, also
activate to indicate the presence of
an alarm.
Chapter 2
Fire Alarm Ack Key
The Fire Alarm Ack key allows you to
indicate that you have observed the
presence of an alarm.
Chapter 2
Priority 2 Alarm LED and
Ack Key
Not normally used in Australia.
N/A
Continued on next page
Basic System Description
Overview
Control Keys
& Indicators
Entry
Keypad