Simon Scena, Руководство пользователя и инструкция по установке

Страница: 99 / 139

99
ENG
5.4.1 Electronic transformer regulator module
Type: Dimmer
General Mode
Advanced Mode
Configuration
Change the
intensity of the
channel, by
sliding a finger
Configuration
In “
general
” mode we can change the intensity of the channel,
by sliding a finger over the grey zone slider.
Advanced
mode, on the other hand, gives us more detailed
control (only in administrator mode)
·
Maximum value:
maximum value to which the luminaire
can be set.
·
Minimum value:
minimum value to which the luminaire can
be set.
NOTE: For luminaires that flicker when turned off, we need to apply
a value between 10% and 20%, depending on the source used, to
solve this problem.
· Selection of the ‘set’ and ‘fade’ time:
Set: Time it takes to get to the maximum luminosity. (Raising
of the signal).
Fade: Time it takes to go out. (Lowering of the signal)
Maximum Set and Fade times: 5s
· Enab Tim: Enable timing, i.e. use a regulator module or
circuit breaker as a timer for its automatic turn-off.
· Time Delay: Time delay, time the luminaire associated with
the module will take to go out.
Maximum time delay: 1000s.
·
Locked status: does not permit changes in the luminaire
by means of the auxiliary inputs (conventional push-buttons).
5.4.2 Electronic Switch-Type Circuit Breaker module
Type: Relay
General Mode
Advanced Mode
Configuration
In “
general
” mode it enables us to change the channel’s
status.
Advanced mode
, on the other hand, gives us more detailed
control (only in administrator mode).
Functions already explained on page 98.