Simon Scena, Руководство пользователя и инструкция по установке

Страница: 91 / 139

91
ENG
3.1.2 Manual registration
To facilitate the acknowledgment and location of each luminaire, pin 10 must be put to OFF, so that the console
assigns the channel to the device it physically has.
Address 0 assigned
If we have an installation in which there are a significant number of devices, this procedure is recommended as
this way the installer always knows the address of each device and its luminaire.
Obligatory registration procedure for:
· DMX-PWM converter
· DMX-DALI converter
* For both devices must use the addresses above 20.
Addresses occupied by these two devices:
· DMX-PWM converter: 3 Addresses
· DMX-DALI converter: Up to 6 configurable addresses
Example of DMX-PWM converter address 21: Occupies addresses 20, 21, 22.
3.1.3 Examples
Address 1 Address 3
Address 31 Address 21
3.2 Recommendations
(Installer)
· Check installation using the TEST screen, Scena will acknowledge and check communication between all the
modules except the protocol converters (DMX-PWM and DMX-DALI).
· Check that each device (channel) is working before configuring the installation with groups, scenarios, se-
quences...
· Make sure that all the devices have a different channel as otherwise the system will not work correctly (except
for the DMX/PWM and DMX/DALI converters that can operate with the same address).
· For a big installation, it is better to assign one channel to each device, that way we know where each device
physically is.
· Whenever we want to eliminate a device that has been found automatically, we have to delete it from the
system first. For the button box, we need to delete the channel in Scena, as otherwise the button box keeps
the channel with which it was registered.
· Automatic mode prevails over all search systems (pin 10 on ON).
· Each device must have a minimum power supply of over 9V.
· Careful with the A and B polarity.