Sime Planet Super 4 F.S., Инструкция по установке и обслуживанию

Страница: 33 / 76

3
– Other faults (fig. 6)
When one of the leds is flashing from
“40÷ 80°C” , deactivate the boiler and
try to start it again. The operation may
be repeated 2 or 3 times, and if there is
no success call the authorised technical
staff for assistance.
Fig. 6
SPIA ROSSA INTERMITTENTE
FLASHING RED LED
MECHANICAL TIME CLOCK
INSTRUCTIONS
Setting the time
Turn the clock dial in a clockwise direction
until it reads the time of the day.
Program setting
Press inwards the segments on the pro-
gram disk corresponding to the selected
switching periods.
Function 1: segment set outwards (C.H. “ON”)
Function 2: segment set inwards (C.H. “OFF”)
Manual override
0 = “OFF” permanently
= automatic programmed operation
1 = “ON” permanently
Programming characteristics
Cycle 24 hour
Number of actions per cycle 96
Program time per segment 15 min.
Min. interval between two actions 15 min.
DIGITAL TIME CLOCK INSTRUCTIONS
When the selector is in the “AUTO” position,
boiler functioning is automatically controlled
on the basis of the temperature levels and
time periods set. The second selector must
be in the “RUN” position to start. The pro-
gramming procedure is described below:
- Setting the time
Set the selector to the “ “ position.
Press “h” to change the hour on the
display, or “m” to change the minutes.
To set the day, press the “1…7” button
until the arrow is pointing to the correct
day (1 = Monday… 7 = Sunday).
- Setting the program
The time clock has 8 on times and 8 off
times. To make it easier to use, the time
clock is supplied with 3 on times and 3 off
times already set for each day of the
week, as shown below:
To select programmes other than those
already set, move the selector to position
“P”; “0:001” will appear on the display, in
which the first three digits indicate the
hour and minutes, while the fourth digit
identifies the program number.
Odd-numbered programs identify reque-
sts for operation (day temperature), in
which case the light bulb symbol will
appear on the display, while even-numbe-
red programs identify drops in tempera-
ture (night). Use the “1…7” key to select
the day of the week (from 1 to 7) or days
(1 ÷ 5, 6 - 7; 1 ÷ 6 or every day if the pro-
gram is to be repeated every day of the
week). Set the hour and minutes with the
“h” and “m” buttons.
Press “P” to store the operation in
memory and go on to the next program.
Repeat the same procedure to set the
remaining programs.
When finished programming, set the
selector to “RUN” position.
Fig. 7
Program Time Operating mode
1 06,00 ON
2 09,00 OFF
3 12,00 ON
4 14,00 OFF
5 18,00 ON
6 22,00 OFF
Note: No program is set from 7 through 17
or
Mechanical time clock
Digital time clock