![background image](http://html1.mh-extra.com/html/silverline/656578/656578_manual_1273484006.webp)
6
GB
Additional Safety Instructions for
Pneumatic Power Tools
Air under pressure can cause severe injury:
• Always shut off air supply, drain hose of air pressure and disconnect tool
from air supply when not in use, before changing accessories or when
making repairs
• Never direct air at yourself or anyone else
• Whipping hoses can cause severe injury. Always check for damaged or
loose hoses and fittings
• Whenever universal twist couplings (claw couplings) are used, lock
pins should be installed and whipcheck safety cables should be used
to safeguard against possible hose-to-tool or hose-to-hose connection
failure
• Do not exceed the maximum air pressure stated on the tool
• Never carry an air tool by the hose
Included Accessories:
½" to
3
⁄
8
" square drive adapter
WARNING:
This device is not a torque wrench. After driving, always use a
torque wrench to torque your fasteners.
Unpacking Your Tool
• Carefully unpack and inspect your tool. Fully familiarise yourself with all
its features and functions
• Ensure that all parts of the tool are present and in good condition. If
any parts are missing or damaged, have such parts replaced before
attempting to use this tool
Intended Use
Square drive ratchet wrench, driven by compressed air from a compressor,
using regular ½" socketry and accessories for driving nuts and bolts.
Before Use
Fitting the quick connector
Note:
This tool is supplied with two different male airline quick connectors:
EQ-4 – commonly used in Europe
EN-6 – mainly used in the UK
• Please choose the connector that is compatible with the airline system
you are using, and install as outlined below:
1. Apply some PTFE tape (not included) to the screw threads of the Quick
Connector (2). This will help to maintain an air-tight seal
Note:
Apply PTFE tape tightly and in a clockwise direction, so it does not
come off when the thread is screwed into the tool.
2. Remove the protective plug from the air inlet
3. Using a spanner (not included) screw the quick connector into the air
inlet located at the base of the handle
4. Connect to airline, pressurise carefully and carry out a leak check
(e.g. by spraying small amounts of soapy water on to the outside of
the connectors)
• Air lines fitted with matching female quick connectors will now be a push
fit to the tool
1
Forward/Reverse Switch
2
Quick Connector
3
Speed Control Trigger
4
½
"
Square Drive
Product Familiarisation
EQ-4
Europe
EN-6
UK
656578_Z1MANPRO1.indd 6
02/07/2013 09:19
Содержание 656578
Страница 2: ...2 1 2 4 3...