12 GB
Overheating protection
The device has an overheating protection
system. If the motor becomes too hot, the de-
vice automatically switches itself off:
1. Switch off the device.
2. Pull out the mains plug
3
.
3. Allow the device to cool down to room
temperature.
When the device has cooled down suffi-
ciently, it can be switched on again.
8.3 Switching the device on/
off and selecting speed
WARNING! Risk of material damage!
~
The mixing mechanism must not be op-
erated continuously for longer than
10 minutes at a time. You must then al-
low the device to cool down to room
temperature.
NOTE:
the device may move slightly while
you are processing large quantities of dough.
1. Switch the device on by turning the
speed control
2
clockwise.
2. Start at a slightly lower speed, and slowly
increase to the desired speed (see “Over-
view of functions” on page 9).
3. Reduce the speed to speed
1 - 2
when
you are adding ingredients during oper-
ation through the filling opening
10
.
4. Set the speed control
2
to
0
to switch
the device off.
NOTE:
above all, the ideal speed depends
on the consistency of the material being
blended. The more liquid the contents, the
faster you can blend them.
8.4 Pulse function
• By turning the speed control
2
to the po-
sition
Turbo
, you can briefly increase
the speed to the highest setting
(8)
.
9. Dismantling the
device
DANGER from rotating parts!
~
Turn off the device and unplug the
mains plug
3
from the wall socket be-
fore disassembling the device.
Lifting up the drive arm
1. Press the unlock button
1
and fold up
the drive arm
12
until it engages and
the unlock button
1
pops out again.
Removing the mixing tool
2. Push the mixing tool
4
/
6
/
7
slightly up-
wards and turn it anticlockwise until it
can be pulled off the axle
13
.
Removing the splash guard
3. Turn the splash guard
11
towards the
open lock symbol until it can be re-
moved.
Removing the mixing bowl
4. Turn the mixing bowl
5
towards the
open lock symbol until it can be re-
moved.
Lowering the drive arm
5. Press the unlock button
1
and move the
drive arm
12
all the way down. The un-
lock button
1
pops out again.
__360499_2010_B6.book Seite 12 Freitag, 5. Februar 2021 11:57 11