Silicon Graphics WebFORCE, Руководство по установке

Страница: 28 / 42

18
Chapter 3: Setting Up the Terminal Emulator and Starting WebFORCE Internet Gateway
2. To start WebFORCE Internet Gateway, type
start-gateway
and press
Enter
. You
see the following:
Welcome to your Silicon Graphics WebFORCE Internet Gateway server!
There are a few simple steps to connect your server to the Internet:
First, use this terminal window to configure your server to
communicate with your local network by means of an IP connection.
Currently, you are using a serial cable connection to communicate
between your server and a terminal device (such as a VT-100
terminal or a PC-compatible, Macintosh, or Indy computer running
terminal emulation software), but the serial connection will be
replaced.
After you configure your server using this terminal window, you
will configure your server to communicate with the Internet. For
this step, you will use a Web browser on your PC-compatible,
Macintosh or Indy computer. Your computer will communicate with
your server through an Ethernet cable.
The current configuration of your server is:
Hostname: IRIS
Domain name:
IP Address: 192.0.2.1
Netmask: 0xffffff00
You must change these factory settings to connect your server to
the Internet. Most of the information that you need to make these
changes is supplied by your Internet service provider (ISP). Make
sure you have the appropriate information from your ISP, and follow
the steps below.
A hostname uniquely identifies your Silicon Graphics Internet
Gateway server. By convention, hostnames contain only lowercase
letters.
Enter a hostname for this server: [IRIS]
■
Enter the hostname you wish to assign to the server at the prompt
Enter a
hostname for this server: [IRIS]
and press
Enter
.