Silicon Graphics WebFORCE, Руководство по установке

Страница: 27 / 42

Logging In to the Server and Initializing WebFORCE Internet Gateway
17
Follow these steps to log in to the server and initialize WebFORCE Internet Gateway:
1. At the
IRIS login:
prompt, type
root
and press
Enter
.
■
You see various boot-up messages followed by a login prompt similar to the
following:
IRIX Release 6.5 IP22 Version 02111257 IRIS
Copyright 1987-1998 Silicon Graphics, Inc.
TERM = (vt100)
■
If you set the terminal type in your emulator software to VT100, press
Enter
.
■
If you set the terminal type in your emulator software to another type of
terminal, enter the name of the terminal type (for example,
vt102
or
ansi
) and
press
Enter
. Be sure to use lowercase letters when entering the terminal type.
Like all UNIX operating systems, IRIX is case sensitive, so VT102 is not the
same as vt102.
You should now see the root shell prompt,
IRIS 1#
.
You can now do one of the following:
■
Leave your terminal emulator session running and leave the serial cables
connected from your client system (system console) to the gateway server. You
may wish to do this at least until you are sure the server is running and
configured properly.
■
Quit the terminal emulator session and disconnect the serial cables between
your client system (system console) and the gateway server. This is appropriate
when you are sure your network and the gateway server are configured
properly.
■
If you are using a character (ASCII) terminal, you can leave it attached to the
server.