Silicon Graphics WebFORCE, Руководство по установке

Страница: 23 / 42

Accessing the Server
13
Accessing the Server
Follow these steps to access the server:
1. Turn on the server, if you have not done so already.
2. Press
Enter
once or twice on your computer or terminal. You should see a
power-on diagnostics message, followed by a menu similar to the following:
Running power-on diagnostics...
System Maintenance Menu
1) Start System
2) Install Software
3) Run Diagnostics
4) Recover System
5) Enter Command Monitor
Option?
■
If you do not see the System Maintenance Menu, and nothing happens when
you press
Enter
, make sure the cables are correctly attached. The 8-pin
connector on the long serial cable must be in port
1
of the server.
■
Make sure you have configured the terminal emulator to use the correct serial
port on your computer.
■
If you are using a character (ASCII) terminal, make sure the baud rate setting is
correct (9600 baud). Also, if the terminal has more than one connector on the
back, make sure you are using the correct one. It should be the connector
marked “Data,” “Modem,” or something similar. Make sure the terminal is
configured to use that connector.
■
If you see strange characters on your screen (such as
xx‘‘x‘
) when you press
the return key, you may not have set the baud rate correctly in your terminal
emulator or character terminal. It must be set to 9600 baud.