Silicon Graphics WebFORCE, Руководство по установке

Страница: 22 / 42

12
Chapter 3: Setting Up the Terminal Emulator and Starting WebFORCE Internet Gateway
Configuring Your Terminal Emulator
Table 3-1 shows the basic settings for terminal emulator software running on IBM
compatible or Macintosh computers.
To configure your terminal emulator, follow these general steps:
1. Power on your IBM compatible or Macintosh computer.
2. When the system has booted, locate and start the terminal emulator.
3. Adjust the settings for your terminal emulator as indicated in Table 3-1.
■
Be sure the terminal emulator software is configured to use the serial port on
your computer to which you attached the serial cable.
■
Note which terminal type (such as VT100 or ANSI) you choose to emulate. You
will need this information when you log in to the server.
■
Other settings, such as upload and download protocol, initialization strings,
and file transfer settings do not matter for this procedure. You can leave them
set to their defaults.
Table 3-1 Terminal Emulator Settings
Setting Value
Baud rate 9600
Data bits 8
Stop bits 1
Parity None
Local echo Off
Terminal type Any of the following:
DEC VT100, VT102, Wyse 60, ANSI, or dumb
Flow control None or XON/XOFF