Silicon Graphics Prism, Руководство пользователя

Страница: 209 / 250

Using Silicon Graphics Prism Modules with a Rack
007-4701-003 187
Attaching the Slide Rail to the Rack
To attach the slide rail to the rack, follow these steps:
Tip: The slide rails must be level in the rack. To ensure that you install the slide rails correctly,
carefully count the mounting holes on all of the rack rails (the two front rails and the two rear
rails).
1. Locate eight 10-32 x 1/2-inch Phillips screws, eight shoulder washers, and four bar nuts.
2. Place one of the bar nuts inside the rack and align it with the second and third holes of the
selected 2U of space (see Figure B-5).
Note: The holes in the bar nuts are not centered. The bar nuts need to be placed in such a way
that the holes are closest to the inside edge of the rack rails. See Figure B-5.
3. Insert two screws with shoulder washers through the rack rail to hold the bar nut in place.
The screws should not be tightened at this point.
4. Repeat steps 2 and 3 to install the remaining three bar nuts on the other three rack rails (front
and rear of rack).