Chirp Delete
The control module can be programmed by the dealer so there will be no arm/disarm status chirps. The
four chirp tamper disarm warning indicator will always be on for your safety.
Pathway Illumination
If the pathway illumination function has been programmed on by your dealer your vehicles parking lights
will illuminate at the time the security system is disarmed by the remote transmitter. The parking lights
will remain on for 30 seconds after the security system is disarmed. Turing on the ignition key will turn
off the parking lights before 30 seconds.
Last Door Automatic Arming
If your Silencer security system was programmed to automatically arm without using the transmitter,
repeat the following procedures to test and operate this feature:
1. Enter the vehicle and close all the entrances.
2. Set the ignition key switch to the on position and wait for 5 seconds.
3. Set the ignition key switch to the “Off” position and exit the vehicle. Upon closing the door, you will
hear a beep from the horn/siren. The beep is an indicator that the automatic arming timer has started
counting. You will also notice that the LED indicator is flashing fast. This is also an indicator that the
automatic arming timer is counting down.
4. Within 30 seconds, the horn/siren will beep once again. This is an indication that the security system
is now in the armed mode. The LED will begin flashing at a normal rate.
Note: Once the ignition key switch is turned “Off, the automatic arming timer will start counting after the
last protected entrance is closed. Reopening any protected entrance within 30 seconds will stop the
counter and reset it. Closing the entrance will start the counter once again, but you will not get a beep
when closing the door for the second time.
Ignition Key Controlled Door Locking/Unlocking
If the ignition key lock/unlock function has been programmed on by your dealer the doors will
automatically become locked 3 seconds after the ignition key is set to the on position or unlocked after
ignition key is turned off.
1. Enter the vehicle and close all protected entrances.
2. Turn the ignition key to the on position.
3. Within 3 seconds the door locks will become locked.
4. Turn off the ignition key. The door locks will become unlocked.
Notations About Ignition Controlled Locking
A. If a protected door is open, the ignition door locking function is disabled.
B. If the door locks are manually locked, the alarm system will still unlock them when the ignition key is
turned off.
Optional Features (Continued)
7
7959PUM.qxp 6/3/05 14:58 Page 7