4
Basic Operation
This section details the simple day-to-day operations of your Silencer security system.
The enclosed procedures should be performed every six months to insure that all functions are operating
properly. To perform a basic operations test, repeat the following steps:
1. Exit the vehicle and close all protected entrances.
2. Press the “Lock” button of your keyless entry transmitter. Your Silencer security system will respond
in the following manner:
A. The horn/siren will beep one time.
B. The LED status indicator will begin flashing.
C. The parking lights will flash one time.
3. Press the “Unlock” button on your keyless entry transmitter. Your Silencer security system will
respond in the following manner:
A. The horn/siren will beep twice.
B. The LED will be off. (Only when the unit has not been programmed to automatically arm).
C. The parking lights will flash two times.
4. Rearm your Silencer security system and wait 5 seconds.
5. Open one of the protected entrances of the vehicle. Your Silencer security system will respond in the
following manner:
A. The horn/siren will begin to sound.
B. The parking lights will begin to flash.
C. The LED flash sequence will change to indicate that the security system had been triggered.
6. Press the “Unlock” button on your keyless entry transmitter once again.
A. The horn/siren will stop sounding.
B. The parking lights will stop flashing.
C. The LED will remain flashing to indicate that the security system had been triggered. (Tamper
indication)
7. Repeat steps 1 thru 6 for all other protected entrances and additional sensor devices.
Notations on Basic Testing and Operating Procedures
1. When you disarm the security system while the horn/siren is sounding the normal disarm beeps are
eliminated.
2. If the chirp status indication function is programmed “Off”, you will not get any arm or disarm beeps.
3. After the security system has been triggered, the LED will remain flashing even though the security
system has been disarmed. This is a tamper indicator. Turning “On” the ignition key will reset the
tamper indicator.
Primary Feature Operations
Take a moment to become familiar with the operation of the primary features provided by your new security
system as you may need to use them at some point in time. To test the primary features, repeat the
following steps exactly as they are listed.
7909P
7959PUM.qxp 6/3/05 14:58 Page 4