Silca D411202XA, Руководство по эксплуатации

Страница: 20 / 30

LANCER PLUS Operating manual
16 Copyright Silca 1998
7.2 Cutting of keys FLAT LEVER CUTS
Install the keys and duplicate as follows:
1) lowering the motor carriage using the lever (G1) until the original bit is aligned with the center mark
on the tracer (fig. 19, page 15) and lock using knob (H) (fig. 6, page 7).
2) proceed to duplicate the key using lever (F).
Fig. 20
7.3 Cutting of FLAT STEEL KEYS
1) position the main carriage on the left hand side (pos. 1 - fig. 12) and rotate the jaws 180°.
2) install the keys using the tip stops (J) in the slot located on the right hand side of the jaw.
3) lower the motor carriage using the lever (G1) until the original bit is aligned with the center mark on
the tracer and lock using knob (H).
4) proceed to duplicate the key using lever (F).
Fig. 21
J