Silca D411202XA, Руководство по эксплуатации

Страница: 19 / 30

LANCER PLUS Operating manual
Copyright Silca 1998 15
7 CUTTING OPERATIONS
• Cutting of keys with radiused lever cuts (CHUBB type)
• Cutting of keys with flat lever cuts
• Cutting of flat steel keys
• Cutting of keys with side and bullet wards
IMPORTANT!
For complete safety during the cutting operations, take the following precautions:
• Always work with dry hands.
• Check that the machine is properly earthed.
• Wear protective goggles even if the machine is provided with a safety shield over the cutting tool.
• Do not turn on the motor (lever switch), unless keys are placed into jaws beforehand.
• Keep hands away from the cutting tool in motor.
7.1 Cutting of keys with radiused lever cuts (CHUBB type)
After inserting the keys proceed as follows:
1) grasp both levers (F) and (G) (fig. 6, page 7).
2) lower the motor carriage using lever (G) until the bit of the key is aligned with the center of the cutter
and tracer and operate the switch in the handle introducing the bit of the original key onto the tracer
by moving forward handle (F), rounding the bit of the key is achieved by raising and lowering the
motor carriage through handle (G1).
Fig. 18
Fig. 19