Silca D411202XA, Руководство по эксплуатации

Страница: 14 / 30

LANCER PLUS Operating manual
10 Copyright Silca 1998
4 MACHINE INSTALLATION AND PREPARATION
The key-cutting machine can be installed by the purchaser and does not require any special skills.
The machine is supplied ready for use and does not need to be set up, except when changing to different
tools. However, some checks and preparation for use need to be carried out by the operator.
4.1 Checking for damage
The LANCER PLUS key-cutting machine is solid and compact and will not normally damage if transport,
unpacking and installation have all been carried out according to instructions.
Notwithstanding, it is always advisable to check that the machine has not suffered any damage.
4.2 Atmospheric conditions
To ensure that the best use is made of the LANCER PLUS key-cutting machine, certain parameters must
be borne in mind:
- damp, badly ventilated sites should be avoided.
- the ideal conditions for the machine are: temperature: from 0 to 40°C; relative humidity: approx. 60%
4.3 Positioning
Place the key-cutting machine on a horizontal surface, solid enough to take the weight.
The workbench should be approx. 100-120 cm high to give easy access to the working parts of the
machine.
Leave enough space around the machine (20-30 cm) to ensure good ventilation and room for
manoeuvre.
ATTENTION: ensure that the key-cutting machine voltage is suitable for the mains supply available, which
must be earthed and provided with a differential switch.
4.4 Description of work station
The key-cutting machine needs only one operator, who has the following controls at his/her
disposal:
• master switch (R) placed on the front of the machine.
•
motor switch (G1) placed on the vertical lever handle (G).
•
levers:
- lever (F) main carriage movement (axes X-Y)
- lever (G) vertical carriage movement (axis Z)
Fig. 7
F
G
R
G1