Siko MSK210, Перевод оригинальной инструкции по установке, Страница: 22 / 32

MSK210
Installation English
MSK210 · Date 08.02.2018 · Art. No. 81417 · Mod. status 41/18
22
4.3 Mounting the magnetic sensor
Alignment of the magnetic sensor
` Take care that the magnetic sensor is aligned correctly in order to
ensure optimum sensing (see
Fig. 6
).
1. Mount magnetic tape (see chapter
4.2
).
2. Fasten the magnetic sensor via the thru-holes (2x ø3.5 mm) on an
even work surface (for the fastening dimensions refer to the Data
Sheet). We recommend to use the enclosed fixing screws and washer
springs (fastening torque design 0.25 Nm).
3. Place distance gauge with its complete surface between sensor and
magnetic tape. Note: only relevant for sensors without reference sig-
nal R.
LINEAR application MSK210 with MB200/1:
1
Active side magnetic tape
2
Travel direction signal A
before B
3
Direction of outgoing cable
4
Admissible deviation of
tape/sensor
0.1 ... 1 mm reference point
O, I
0.1 ... 0.4 mm reference
point R
5
Maximum alignment error
6
Admissable deviation middle
of tape/sensor
ref. O, I ±2 mm
ref. R ±0.5 mm
7
Position of the reference
point relating to the mark-
ing on the magnetic tape
Fig. 6: Definition of the counting direction with magnetic tape and
assemblage sensor / magnetic tape, gap measure, tolerances
5
6
7
1
3
4
2
MBxxxx GEK WT RP NNNNNN
<1°
<3°
<1°
NOTICE