Siko AG02, Информация пользователя

Страница: 23 / 24

AG02 Datum 14.09.2011 Art. Nr. 82270 Änd. Stand 343/11 23
Fig. 16: Possible angle positions












Fig. 15: Right angle mating connector









 

Fig. 14: Straight mating connector
Straight mating connector (8 pole Inputs PWM)
8-pole connector ( Inputs PWM ) Available from SIKO
as accessory art. no. 81351. Wire cross section is to
be at least max. 0,14 mm². Cable channel: max. 5
mm.
Please proceed as follows (fig. 14):
1. Mount seals (2 & 4) on female contact (3).
2. Stringing Pressing screw (9), pinch ring (8), seal
(7) and snap bushing (6).
3. Turn on the pressing screw (9) very slightly.
4. Dismantle cable, strip and tin conductor.
5. Shorten and turn down screen.
6. Fit screen collar (5) to cable diameter, then clip
it on and solder it so the screen.
7. Solder and insert female contact (3) (after relea -
sing pressure screw (9)).
8. Mount connection ring (1).
9. Fix pressing screw (9).
7. Solder wires on insert (7).
8. Mount positioning sleeve (8) in angled position.
9. Set in insert (7) and distance sleeve (9).
10. Mount cover (10).
11. Fix pressing screw (2) (approx. 10 - 20 Ncm).
Right angle mating connector (3 pole; 12 pole)
12-pole connector ( Incremental encoder ) Available
from SIKO as accessory art. no. 79666. Wire cross
section is to be at least 0,14 mm², max. 0,25 mm².
Cable channel: 6 - 8 mm.
3-pole connector (Motor) Available from
SIKO
as
accessory art. no. 81363. Wire cross section is to be
at least 2x 0,75 mm². Cable channel: 4 - 6 mm.
Please proceed as follows (fig. 15):
1. Mount seals (1) (3x).
2. Stringing pressing screw (2), pinch ring (3), seal
(4), shielding ring (5).
3. Dismantle cable, shorten screening, strip and
tin conductor.
4. Thread-up wires through the housing (6).
5. Mount shielding ring (5) and pinch ring (3).
6. Turn on the pressing screw (2) very slightly.
Changing the angle position (fig. 15 + 16):
1. Slightly unscrew pressing screw (6).
2. Remove ring nut (8).
3. Slightly pull out female contact (7) and rotate
to desired angular position (in steps of 45°).
4. Mount female contact; tighten ring nut and
pressure screw.
Attention
Multiple angle adjustments to a single direction
cause shortening of the line and break.