EtherHaul Operation, Administration and Maintenance Manual
Page 119
cfm-peer-mep 2 2 1 2 mng-addr-domain : unknown
Configure the Loopback on the Local System
The following set of commands sets up the Loopback on the local System. You must set
the destination type (mepid or mac) and the destination MEP ID, determine the number
of loopback packets to transmit, and enable the Loopback for transmit.
Enter the following commands on the link level:
set cfm-mep 1 1 1 lbm-dst-type mepid
set cfm-mep 1 1 1 lbm-dst-mepid 2
set cfm-mep 1 1 1 lbm-tx-num 10
set cfm-mep 1 1 1 lbm-tx-status tx-pending
Enter the following commands on the customer level:
set cfm-mep 2 2 1 lbm-dst-type mepid
set cfm-mep 2 2 1 lbm-dst-mepid 2
set cfm-mep 2 2 1 lbm-tx-num 10
set cfm-mep 2 2 1 lbm-tx-status tx-pending
To view the loopback reply, you must first verify the number for
lbr-in-order
. You
can then transmit the loopback packets, using the following command:
set cfm-mep 1 1 1 lbm-tx-status tx-pending
Re-check the number for
lbr-in-order
to verify that all packets were received.
show cfm-mep
cfm-mep 1 1 1 interface : eth0
cfm-mep 1 1 1 dir : down
cfm-mep 1 1 1 vlan : none
cfm-mep 1 1 1 admin-state : active
cfm-mep 1 1 1 cci : enabled
cfm-mep 1 1 1 msg-prio : 0
cfm-mep 1 1 1 low-defect : mac-rem-err-xcon
cfm-mep 1 1 1 alarm-time : 250
cfm-mep 1 1 1 reset-time : 1000
cfm-mep 1 1 1 lbm-dst-mac : 00:00:00:00:00:00
cfm-mep 1 1 1 lbm-dst-mepid : 2
cfm-mep 1 1 1 lbm-dst-type : mepid
cfm-mep 1 1 1 lbm-tx-num : 10
cfm-mep 1 1 1 lbm-tx-data-len : 0
cfm-mep 1 1 1 lbm-tx-prio : 0
cfm-mep 1 1 1 lbm-tx-drop : enable
cfm-mep 1 1 1 ltm-dst-mac : 00:00:00:00:00:00
cfm-mep 1 1 1 ltm-dst-mepid : 1
cfm-mep 1 1 1 ltm-dst-type : mac
cfm-mep 1 1 1 ltm-tx-ttl : 64
cfm-mep 1 1 1 lbm-tx-status : tx-idle
