Cutter operating instructions
USER MANUAL
18
5.3.7 Setting parameters for different states
5.3.7.1
Setting down force
In the off-line state,
“
Press
”
means down force. To increase down force, press
“
+
”
. To lower,
press
“
-
”
. The values range from 0~255. These values adjust the down force from 0 to 800g.
When the machine is running and the down force is found unsuitable, press the
“
PAUSE
”
button.
Then press
“
+
”
or
“
-
”
to adjust the down force.
5.3.7.2 Setting Self Test interface
In the
“
Test
”
state, press
“
+
”
to increase the testing times or press
“
-
”
to decrease testing
times, the range of testing times is 0 ~ 255. Press the ON LINE button to start a plot Demo Test
graph. Testing with the installed blade should only be done once. To repeat the testing, replace the
blade with a plot pen with which you can repeatedly test the precision of the cut. A successful Self
Test indicates that the machine is in good condition.
5.3.7.3 Repeating the cut
The data the computer transmits to the cutter can be stored into the memory of the machine;
this function can be used to plot repeated copies. In the
“
Repeat
”
mode, press
“
+/-
”
to adjust total
copies to be duplicated, press
“
ON LINE
”
to start plotting. The maximum number of copies that
can be duplicated is 255. Note: the maximum size of the print job must be smaller than the size of
the buffer (1024kb).
