Signode AMPT-12, Операция, части и безопасность

Страница: 3 / 36

3
6. TOOL CARE.
Take good care of the tool. Inspect and clean it daily, lubricate it weekly and adjust when
necessary. Replace any worn or broken parts.
7. WORK AREA.
Keep work areas uncluttered and well lighted.
Several types of strap can be used with this tool. Use the correct Signode products for your
application. If you need help contact your Signode Representative.
SAFETY PROCEDURES FOR TOOL OPERATION
1. Before using this tool, read its Operation and Safety instructions.
!
! !
!
Do not exceed the operating air pressures stated elsewhere in the manual.
! ! ! !
Use Signode's approved filter-regulator-lubricator unit (P-173111).
! ! ! !
Never operate a pneumatic tool with a bottled air or gas source.
!
! !
!
For tension adjustments, follow instructions in this manual. For all other adjustments,
repairs or cleaning of the tool, disconnect air supply.
! ! ! !
This tool has a crimp type sealer. A properly made joint will appear as
shown in the illustration. If the joint does not appear as shown, then the
operator must proceed as follows:
A. Insure that the tools operating instructions are
being followed before applying another strap.
B. Cut the strap off and apply another.
If the joint still does not appear as shown, then inspect the tool for worn and/or
damaged parts. Replace tool parts as needed. NEVER HANDLE OR SHIP ANY
LOAD WITH IMPROPERLY FORMED JOINTS. Misformed joints may not secure
the load and could cause serious injury.
!
! !
!
Tuck strap end back into the dispenser when not in use.
CUTTING TENSIONED STRAP
Use only cutters designed for cutting strap; never use claw hammers, crowbars, chisels, axes or
similar tools. Such tools will cause the strap to fly apart with hazardous force. Before using any
Signode product, read its Operation and Safety Manual.