Signode AMPT-12, Операция, части и безопасность

Страница: 8 / 36

8
STRAP TENSION
The AMPT-12 tools are factory tested to
ensure that at least 350 lbs. (1554N) of
tension is drawn at 90 psig (6.2 Bar).
NOTE: Make sure the input air pressure to
the tool is set between 65 and 90 psig.
Strap breakage hazard. Strap can break
while tension is being increased. Stand
to one side of the strap as it is being
tensioned. Failure to do so could result
in personal injury.
To adjust the AMPT-58 strap tension, use the
following instrcutions:
1. Loosen the set screw on the side of the
air motor.
2. Turn the pressure adjustment screw in
increments of 1/8 turns clockwise to
decrease strap tension and counter-
clockwise to increase strap tension.
3. Turn the adjustment screw until the
desired tension level has been reached.
4. When a satisfactory tension level has
been reached tighten the set screw.
The tool is now set to operate at a given air
pressure in combination with a particular
strap size. Any change in air pressure or
strap size could result in unsatisfactory tool
performance or strap breakage.
LOADING SEALS
To load seals, raise the seal pad assembly
and insert a stack of seals inside the seal
magazine. Release the seal pad. Activate
the sealing mechanism by depressing then
releasing the sealing lever. A seal will be
ejected into the sealing jaws. An extension
on the seal pad closes the top strap loading
slot as a reminder to add seals.
CUTTER ADJUSTMENT
If the cutter on the tool does not cut properly,
loosen the shoulder bolt (39) and cap screw
(42), and adjust set screw (44) to remove
clearance between the cutter blade and the
cutter block. Adjust with the jaws in the
down position. Do not over tighten as the
sealing mechanism can be bound by this
adjustment. When adjustment has been
made, retighten the shoulder bolt and cap
screw.