Signode AMPT-12, Операция, части и безопасность

Страница: 18 / 36

18
TOOL HOUSING, DISASSEMBLY & REASSEMBLY, Continued
Connect air supply and hold in sealer lever (8). With jaws in fully downward position, adjust the
cutter adjustment screw (44). Tighten both magazine screws (39 & 42) through the sealer frame.
Insert seals into the magazine and operate the sealer mechanism at it's recommended air pressure
through 3 or 4 cycles to check tightness of the cutter adjustment screw and see that seals feed
properly. If the sealer mechanism is excessively tight, back off the cutter adjustment set screw
slightly.
Apply a strap under tension to be sure that all elements of tool operate properly.
SEAL EJECTOR & EJECTOR LEVER - DISASSEMBLY
Remove the seals from the magazine. Remove
the Truarc (73) from the left side of the ejector
arm pin (72) then drive out ejector arm pin (72)
from the left side of tool. Remove ejector arm
spring (59). Hold gripper lever (58) down, pull
out ejector lever (60).
Drive out roll pin (63) from ejector pin (64). Be
sure to support ejector lever. Remove pin (64),
ejector (62) and spring (61). Replace the ejector
lever and/or the ejector as necessary. Re-
assemble with new ejector following these steps
in reverse order.
NOTE:If the ejector only needs to be replaced, it
can be removed without removing the ejector lever
following the 3 steps above.
SEAL EJECTOR & EJECTOR LEVER - ASSEMBLY
Insert ejector (62) into cutter block (71) slot, hold gripper
lever (58) down and slide ejector lever (60) into position.
Insert ejector arm spring (59) ahead of the top of the
ejector arm so it will slide under the edge of the cylinder.
Start ejector arm pin (72) through right side of ejector
lever and magazine.
Insert a punch from the left side to hold the spring in
alignment. Tap ejector arm pin (72) in from the right side,
while removing the aligning punch at the same time.
Push on lower part of ejector lever (60) to align holes on
left side of tool. Finish tapping in ejector arm pin (72).
Replace Truarc (73). Insert seals in the magazine.
Operate the sealer mechanism through 3 or 4 cycles to
check and see that seals feed properly. Apply a strap
under
tension to be sure that all elements of tool operate properly.